|NAME||FULL SET CENTRAL LUBRICATION PUMP|
|MODEL NO.||BE2232 TYPE|
|MATERIAL||DIE-CAST ALUMINUM +RESIN MATERIAL|
|Model||Structure||Flow (ml/min)||Max pressure (kgf/cm2)||Lubricating point||Oil Viscosity (mm2/s)||Low oil level reminders||Motor||Tank volume (L)||Weight|
|BE2232-1.5||Automatic With timer or without timer||100-150||15-17||1-180||30-1200||Have||AC110V/ AC220V||28||50/60||1.5||2.45|
1.See wiring instructions inside the top cover.
2.Must use lubrication oil (30#-68#)
3.The device has lubrication, intermittent, setting, and detection functions.
a. Lubrication/intermittent time can be set.
“ACT” green light are turn on is supply oil 1-999S .
“INT” red light are turn on is intermittent time 1-999M/S .
b.Press the SET button for about 3 seconds, The liquid crystal body flashing the original oil supply time value, press key or decrease (1- 999 sec) to set the required oiling time.
After increasing or decreasing the oil supply time, press the SET button for about 3 seconds， The liquid crystal flashing , and press the key or decrease (1 – 999 seconds/min) to set the desired intermittent time.
After increasing or decreasing the intermittent time, press the SET button for about 3 seconds. At this time, the system has deleted the original oil supply and the intermittent time value, and has locked the set oil and intermittent time values, and press the setting system. Automatic cycle work.
During intermittent time, press the SET button for about 3 seconds.can restart again .
4.The intermittent time “minute and second” interchange function seting ;
During the lubricating time, when the ACT green light is on, keep pressing SET key , the number will flash after 10 times ,can reach the minute / second conversion.
Press the SET button or RESET the switch key to immediately recirculate the oil system.
6.Alarm function When the system is detected abnormally, the number flashes and beeps, and the electric pump stops working.
a、” Ero “will be displayed on the system liquid crystal, when lack oil .
b.” Ero “will be displayed on the system liquid crystal,when system pressure is not enough (check volumetric system )Check whether the pipeline is damaged or leaking, or the lubrication time is set too short, (no pressure switch,without this function ).
c. ” Ero “will be displayed on the system liquid crystal when the system is running overtime.
7.Function of two valve on gear pump:
a. Pressure regulating valve (relief valve).
Can be adjusted to the required pressure value.
b. Decompression action valve.